Site Loader

INTRODUCTION. Congratulations on purchasing the dbx Model XT Compressor/Limiter. We recommend you take a moment and read through the manual. dbx x. PROFESSIONAL SINGLE-CHANNEL. COMPRESSOR/LIMITER. INSTRUCTION MANUAL. Used with the permission of AKG ACOUSTICS, INC. View and Download Dbx X instruction manual online. X Music Mixer pdf manual download.

Author: Arashigrel Totilar
Country: New Zealand
Language: English (Spanish)
Genre: Spiritual
Published (Last): 8 April 2017
Pages: 93
PDF File Size: 8.59 Mb
ePub File Size: 14.67 Mb
ISBN: 451-6-75326-201-7
Downloads: 68491
Price: Free* [*Free Regsitration Required]
Uploader: Dudal

Be sure to verify both your actual line voltage and the volt- age for which your Model XT was wired, as indicated on the rear panel of your unit. The sound of the unit is not what I want in a compressor for all things.

All user reviews for the dbx 160X

If you use two X stereo from time to time, you can leave the jack coupling continuously. Verify that the 1 60XT package contains the following: Your 1 60XT was carefully packed at the factory in a protective carton. To compress a live mix or to protect loudspeakers, connect the XT be- v: This will provide accurate dvx for a stereo programming.

However, it will generally be found that large amounts of compression are more audible in a mixed stereo program than they might be on the separate tracks that were mixed to cre- ate the program.

The XT will catch it, and hold it as a constant tone so you can adjust your EQ to minimize it. Compression lessens the loudness variations among the strings and increases the sustain.

It is good for drums and guitars, but lacks the full quality I would look for in a vocal compressor. If you are not use to the sound of the DBX compressors it is very distinguishable to my ears.


For a stereo sound-reinforcement system, stereo strapping cables should be run between the XTs in each band low-low, mid- mid, etc. I like the Blue Nanual better for the studio personally.


This is equivalent to a cable with V 4 ” Mono Phone plugs on both ends. He had with him-among others-2 dbx X.

If two independent compressors are used to process the stereo program, a loud sound occurring in one channel will cause a gain reduction only in that channel. Anyway, it’s very simple. Mark the package with the name of the shipper, and with these words in red: Patch bay In the studio, the 1 60XT may be connected to a patch bay to allow it to be used anywhere in the studio system.

The over-easy is the voice or if you just want to smooth the level of an instrument maual audible compression effect. Assuming the tom-tom is a lower frequency instrument and can be better tolerated by the tape, it has less need for compression.

I would buy a better compressor such as the Empirical Labs or a really high end unit. If you need to return a product to xbx factory for service, include a letter describing the problem. Due to the gentle OverEasy characteristic of your XT you will find that even fairly high ratios are handled transparently. Another option is to install an output trans- former, which will allow grounding 160 either pin 2 or 3 of the XLR-type out- put see page manul If the XT is wired into a patchbay, never insert a mono phone dxb into the patchbay.

Our members also liked: Using your EQ to reduce feedback in live settings.

DBX X SCH Service Manual download, schematics, eeprom, repair info for electronics experts

A setting of 2: Mono Analog Compressor Rack 1U in height. With some experimen- tation, the effect can be that of zero attack time at a given frequency. An unbalanced line is generally a single-conductor shielded cable with the center conductor carrying the signal and the shield at ground potential.


Insure the package properly. I don’t have a manual for this so I don’t know if it helpful or not, but the unit is easy enough to use that most shouldn’t need it except maybe during set up or troubleshooting. Modif easy to do for qq’un who really knows a bit of soldering components. Mounting the unit directly over large heat-producing devices such as a vacuum-tube power amplifier may shorten component life and is not rec- ommended.

I did not have the manual but I found the site DBX see abovethere is also that of the A same thing but easier to read in English only.

And A are made in China Each XT is tested, burned in and calibrated at the factory and should require no internal adjustment of any type throughout the life of the unit. By using our services, you agree to our use of cookies.

I have not read the manual, it’s stuff that “feels”, I mixed the whole weekend with and I wonder if I’ll really take the trouble to read the manual I mainly placed above the bass, then taken to the mix with a different setting each time. It has XLR connections in the back and is rackable – it will take up a single rack space. Please refer to the terms of your Limited Two-Year Standard Warranty, which extends to the first end-user.

What I like least: