Site Loader

Circuit that is used in DENON’s high-end integrated amplifiers and has been criti- The PMAAE employs DENON’s Signal Level Divided Construction. A broad-branded circuit technique and a single-stage output circuit on high- current transistors are used in PMAAE. The equalizer, loudness scheme ( both. Denon PMAAESilver Amplifier. Great Integrated Amplifier.

Author: Narr Goltik
Country: Iceland
Language: English (Spanish)
Genre: Medical
Published (Last): 22 April 2014
Pages: 431
PDF File Size: 10.44 Mb
ePub File Size: 2.12 Mb
ISBN: 143-3-15932-496-7
Downloads: 80108
Price: Free* [*Free Regsitration Required]
Uploader: Vilrajas

At 1kHz, the Denon delivered a little more again watts, or The Denon was no slouch into 4O loads either, producing watts You can clearly see the power supply limitation at 20Hz however, where the Denon returned watts Channel separation was good, with a best of 79dB at 20Hz, reducing to 72dB at 1kHz and 48dB at 20kHz, however the balance between the left and right channels was very slightly out, with a 1.

This is not a large error: Phase error at 20kHz was a little on the high side, but nothing to be concerned about. Distortion was very low, as you can tell from the spectrograms.

  ELEKTRONSKA VEZJA PDF

With a 4O load, the second harmonic component crept up to —90dB 0. Distortion increased at rated output, as would be expected, with the lower-order harmonics increasing in level, pja-700ae additional, higher-order components appearing above the noise floor.

However, all the low-order harmonics were pm-a700ae or below —80dB 0. Of some significance was the CCIF intermodulation test, which showed two sidebands at 18kHz and 21kHz surrounding the 19kHz and 20kHz test signals but only the tiniest re-generated signal at 1kHz, at —dB.

Even the two sidebands were an excellent pma–700ae. This is exceptional performance, by any standard. The overall THD figures are tabulated in the chart, at 0.

Damping factor was very good: With the tone controls engaged, the low-frequency response slopes down from 1kHz to end up 2dB down at 80Hz and a further 0. Square wave performance was excellent, with the Hz square wave showing negligible tilt and almost no curvature across the flats.

The 1kHz wave was nearly perfect, and the 10kHz wave showed a very fast rise-time with very little rounding.

  DALLAS DS1820 PDF

Stability into an extremely capacitative load was excellent. As you can see, what little ringing there was was quickly damped. Since Dneon was interested to re-check the balance and frequency response tests on a fresh sample, I borrowed a brand-new PMAAE and had Newport Test Labs rerun the balance and frequency response tests on this second sample.

Denon PMAAE Amplifier Review & Test | Hi-Fi | Review | AVHub

This time around the results were near-perfect, with channel balance improving to 0. You can download a pdf of the original magazine pages on which this review was published, which includes all the graphs, test result charts, tabulated results and oscillograms mentioned in the test results, by clicking HERE or on the graphic at right.

David Ella and tested by Steve Holding Magazine: And for the price, excellent hi-fi performance.