Site Loader

Vinyl Cutter Download Graphtec FC, Vinyl Cutter Machine Download Software Installation & Operation Manual in pdf ( MB) > Download Now. Manually Adjusting the FC ARMS Sensor Level for Glossy Media and Glossy Laminated Prints. When using some glossy media or when using glossy. View and Download GRAPHTEC FC Series user manual online. Cutting Pro . FC Series Plotter pdf manual download.

Author: Zuluk Fenritaxe
Country: Mauritius
Language: English (Spanish)
Genre: Relationship
Published (Last): 26 November 2008
Pages: 102
PDF File Size: 3.22 Mb
ePub File Size: 5.68 Mb
ISBN: 938-2-30269-839-7
Downloads: 55935
Price: Free* [*Free Regsitration Required]
Uploader: Yolabar


To print the manual completely, please, download it. Original origin point New origin point When Coordinate Axes are Rotated After Origin Point is Set The origin point will be initialized as shown below if the coordinate is rotated after moving the origin point.

Page – Adjusting for the Registration Mark Scan Bigger registration mark size is better if there is difference in printing or media is set tilted. Page Move the position of the light with strong scattered source. It is possible to set the origin point at the center when the HP- P. Speed It may not scan the registration marks or the difference may become large when the speed is too high, but the cutting time becomes longer when the speed is too slow.

Settings from the controller are not accepted. This improves productivity by shortening scan detection time. M ake the settings of the conditions for the basic operation of the plotter, such as display language, unit of the measurements, sensor, etc.


Press manua [2] key TOOL Push roller Media sensor Media set lever Pass the leading edge of the sheet from the rear of the plotter so that it emerges from the front, making sure that it completely covers the media sensor. Confirm the Results of the Cutting Test Confirm the cutting test results, and adjust to optimal setting. It also can move the tool carriage and media to the origin, or move it certain distance to keep it away.

Don’t show me this message again. One of seven languages can be selected: Setting range is from 0 to Assembly Insert the basket tubes long into both ends and center of the basket.

ARMS (Advanced Registration Mark Sensing system)

Setting the Pouncing Tool Set the distance of the holes ffc8000 continuous holes are to be punched. See “Structure of Cutter Pen” Origin point Copy space Loading Sheet Media Operation Lower the media set lever to raise the push rollers.

It will return to default screen. To prevent injury, avoid touching the tool immediately after the cutting plotter is turned on or whenever the tool is moving. Cross Cut Manually Media is cross cut at the position 15 mm behind the last cut fd8000. E Failed to adjust the sensor level. Settings of Controls from Co Look directly down into the loupe Pen down status When aligning the loupe with a point, use the POSITION keys to ggraphtec the loupe so that the crosshairs are aligned with the center of the target point.


Assembling Assembling Assemble the stand.

Setting of the Cross Cut Force will adjust the blade force when it cross cuts. See “Structure of Cutter Pen” P. Assembly Assemble the left and right stand sides. Dual Configuration FC can save 2 sets of settings independently. Position of the Origin Point and the Registration Mark origin point after scanning the registration mark will be as shown below.

Printing The Setting Of The Plotter 13 – Printing the Setting of the Plotter Condition setting list can be printed when you need to check fc8000 current setting of the plotter. Perform Automatic Pre Feed When Cut Data is Received It is possible to feed and reverse the media automatically for specified amount when the plotter receives the cutting data.

Perform further adjustment by performing cutting test after adjusting the blade length manually. Default factory setup is set as rear loading.