TSOP IR Receiver Modules For Remote Control Systems. Description. The TSOP series are miniaturized receivers for infrared remote control systems. TSOP 38 kHz. TSOP 40 kHz. TSOP 56 kHz. Description. The TSOP – series are miniaturized receivers for in- frared remote control systems . TSOP TSOP 17 Series Photomodules are excellent Infrared sensors for remote control applications. These IR sensors are designed for improved.
|Published (Last):||2 July 2010|
|PDF File Size:||8.79 Mb|
|ePub File Size:||20.10 Mb|
|Price:||Free* [*Free Regsitration Required]|
The circuit can be operated up to a distance of meter depending on the idx1 used. The circuit works on regulated 5V, which is derived from X1 and regulated by IC1. The IR receiver module operates at this frequency. It is used to control relay RL2.
TSOP  : Sunrom Electronics/Technologies
The relay triggers IC2, which is wired in a bistable mode to control the home appliance connected at the contacts of relay RL1. Threshold and trigger input pins 6 and 2 of IC2 are held at one-half of the power supply voltage 5V by resistors R2 and R3. When output pin 3 of IC2 is high, capacitor C4 charges through resistor R4, and discharges when the output pin 3 is low.
When switch S1 is pressed, capacitor C4 voltage is applied to pins 2 and 6 of IC2, which causes the output of IC2 to change from low to high, or high to low. When switch S1 is released capacitor C4 charges or discharges to the original level at the output pin 3 of IC2. The working of the circuit ttsop1738 simple.
Initially, when there are no IR rays falling on the IR receiver module, its output remains high. Transistor T2 is in tsp1738 condition. Relay RL2 does not energies and hence IC2 does not toggle.
Remote Controlled Switch for Appliance
As a result home appliance connected at the contacts of relay RL1 remains switched off. Relay RL2 energizes and triggers IC2. Output of IC2 goes high and relay RL1 energizes to switch on the appliance.
Once relay RL1 is energized it remains in that state. So the appliance which is connected at the contacts of relay RL1 remains tsop7138 on.
TSOP Sensor | TSOP Datasheet | Pin Diagram & Description
Now when you press any remote key the second time, relay RL2 energizes and re-triggers IC2. Output of IC2 goes low and relay RL1 de-energizes to switch off the appliance. Once relay RL1 de-energizes it remains in that state.
So the home appliance remains off. Assemble the circuit on a general purpose PCB and enclose in a suitable cabinet.
Place transformer inside the cabinet and mains power cord at the back of the cabinet. You are commenting using your WordPress. You are commenting using your Twitter account.
You are commenting using your Facebook account. Notify me of new comments via email.
Remote Control Tester
Main menu Skip to content. Place transformer inside the cabinet and mains power cord at the back of the cabinet Like this: Leave a Reply Cancel reply Enter your comment here Fill in your details below or click an icon to log in: Email required Address never made public.